donovan
Joined: 04 May 2006
Posts: 1
|
 Posted:
Thu May 04, 2006 2:41 pm Post subject:
HORM RE ENABLE |
|
|
Hello,
When I first enable HORM with
ewfmgr c: -enable
restart
xpepm -hibernate
the hibernation works fine. If I disbale EWF using ewfmgr c: -disable or commitanddisable, and then go through the re enable proccess, hibernations begins to work just fine again on several attempts.
However, when make a change (load some additional software, make tcp/ip address changes, etc) and then re enable horm, after the xpepm -hibernate command is giving the build locks up and doesn not respond ever..
In this case, I EWF is protected from any changes but hibernation doesn not work.. The only way around this that I can find is to completely reload the build and only activate hibernate after everything is loaded and configured.. which means I can not go back and make any changes.
Is there a fix or a way around this? |
|
FAQ
Memberlist
Register
Profile
Log in to check your private messages
Log in
